![]() If you still have problems i will show u my cable that works ) You are using a db9 header to connect to the computers com1 port? looks like a db25! If the view was from behind monitor= (colours according to your earlier post) Stick with your original design and make sure the pins are configured as follows 6' of 9pin to 25pin, 7' of cat 5, the circuit, and then 8' of cat 5 to the monitor. Continuity is good on all of my lines, but the wires might be a little long. I've tried swapping TX/RX, and I've switched from T2/R2 to T1/R1 - to no avail. I get the infamous "check bus line and condition" message. Of course I've only succeeded in shifting the problem to the cable. ![]() copying the creative labs version of MFC42.dll fixed my software poblems. ![]() The XPSP2 errors were MFC related as well. I've been working on the 98 machine - Microsoft foundation class errors abound. Hope that helps, if not give me more info(computer spec/installed programs) and i will see what i can do. Also try to shutdown all other programs as one might conflict. Did you try your 98 machine yet? On your sp2 machine you could run the file under 98 settings by right clicking on the Windas.exe file going to the compatability tab and selecting which ever mode you want. Hi deiphage, I have sp1 and it works ok on that.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
June 2023
Categories |